Splice Mode - Greenlee 910FS Instruction Manual

Turning Splicer ON
Press and hold
The "Ready" screen is displayed after all the motors reset to their initial positions.
The power source type is automatically identified. If the battery is used, the remaining
battery capacity is displayed.

Splice Mode

Use SM splice mode for standard SM fiber (ITU-TG.652) splicing. It performs splices in
9 seconds and is the quickest mode for SM fiber splicing.
Use AUTO splice mode if fiber type is not identified. Splice takes 2 seconds longer but it
covers most conventional fiber splicing for the following reasons:
Automatic Arc Calibration Function
When the automatic ARC calibration function is enabled the previous splice's ARC
power is used. If the ambient conditions or type of fiber has changed an ARC calibration
may be required. The automatic arc calibration function works in AUTO modes only. It
is not active in the standard splice modes. When using those modes, performing arc
calibration before splicing is strongly recommended.
Greenlee / A Textron Company
until the LED on the keypad turns ON (green color).
• AUTO mode first identifies fiber type by analyzing fiber profile, and the splicing
condition is chosen for the type of fiber. The types of fibers covered by AUTO are
all the conventional fibers, such as SMF (G652), BIF (G657), NZDSF (G655), MMF
(G651), etc. AUTO mode takes longer than the SM processes but is recommended
in cases where the fiber type is not positively identified or if the user is new to fusion
splicing.
• AUTO mode uses an automatic arc calibration function, which monitors the splicing
process and ensures adequate arc power for the splice.
?
12
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
910FS Splicer