Reassembly - Invacare HomeFillII AW Service Manual

SECTION 11—TIMING BELT REPLACEMENT

Reassembly

NOTE: For this procedure, refer to FIGURE 11.1 through FIGURE 11.6.
1. Install new belt over the large pulley and the small motor pulley. Refer to Detail "A"
in FIGURE 11.6.
2. Turn the large pulley and ensure the belt is tracking properly across both pulleys.
3. Position the motor/pump assembly on the base (FIGURE 11.5).
4. Secure the pump/motor assembly to the base with six mounting screws. Torque
mounting screws to 25-30 in-lbs (2.82-3.39 Nm) (FIGURE 11.5).
5. Position control panel assembly on base (FIGURE 11.4).
6. Connect the two connectors (not shown) to the hour meter (FIGURE 11.4).
7. Connect the two connectors to the power inlet (FIGURE 11.4).
8. Connect the four connectors to the transformer as noted in STEP 18 on page 77
(FIGURE 11.4).
9. Connect the oxygen sensor tubing to the oxygen inlet hose and secure with tie wrap
(FIGURE 11.4).
10. Connect the oxygen inlet hose to the receptacle fitting (FIGURE 11.4).
11. Secure the oxygen inlet hose to the receptacle fitting with a tie wrap (FIGURE 11.4).
12. Connect the oxygen inlet hose to the inlet of stage 1 (FIGURE 11.4).
13. Secure the hose with a tie wrap using a tie wrap gun set at #8 (FIGURE 11.4).
14. Secure the control panel gussets to the rear of the base assembly with two mounting
screws (FIGURE 11.1).
15. Secure the bottom of the control panel to the pump assembly with the two mounting
screws (FIGURE 11.3).
16. Connect the high pressure oxygen line to the cylinder fillport connector. Securely
tighten using the
17. Connect the two wires to the high pressure switch (FIGURE 11.2).
18. Connect the grounding clip to the motor (FIGURE 11.1).
19. Connect the two wires to the capacitor (FIGURE 11.1).
20. Connect the two pin connector that connects the motor to the wiring harness
(FIGURE 11.1).
21. Install the cabinet. Refer to Removing/Installing the Cabinet on page 25.
®
HomeFill II AW Compressor
7
/ open ended wrench (FIGURE 11.3).
16
80
Part No 1154316