Unloading The Dishwasher - Atag VA6311QF User Manual

12
– The indicator lights of the phases fore-
seen for the programme start flashing.
5. Press the start/cancel button. The pro-
gramme starts automatically and the
start/cancel indicator light comes on.
– As soon as the programme starts, the
phase indicator lights go off except for
the indicator light for the phase in pro-
gress which will remain on with a static
light.
During the running of the programme, it
is not possible to change the selection
made by turning the programme knob in
correspondence of another programme
or the Off position. If you want to change
the running programme you must cancel
the selection made (see "Cancel a wash-
ing programme in progress").
The washing programme will begin only
after having pressed the start/cancel
button. Until that moment it is possible
to modify the selection made.
Select and start a washing programme
with delay start
Allows the start of the washing programme
to be delayed by 3 hours.
1. Select a washing programme.
2. Press the delay start button. The delay
start indicator light comes on.
3. Press the start/cancel button, the count-
down of the delay start begins
automatically. The phase indicator lights
go off.
Once the delay start countdown has elapsed
the washing programme will automatically
start.
• Delay start indicator light goes off.
• Indicator light of the running phase comes
on.
Opening the door will interrupt the
countdown. Once the door is closed the
countdown will continue from the point
at which it was interrupted

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
Cancel a delay start in progress
1. Press the start/cancel button for about 5
seconds.
– Start/cancel and delay start indicator
lights go off.
– Phase indicator lights start flashing.
2. Press start/cancel button to start the se-
lected washing programme.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
Open the dishwasher door; the programme
will stop. Close the door; the programme will
start from the point at which it was interrup-
ted.
Cancel a washing programme in
progress
• Press the start/cancel button for about 5
seconds. The start/cancel indicator light
goes off and the phase indicator lights are
flashing. The running programme has
been cancelled and it is now possible to
set a new washing programme or switch
off the machine. If a new washing pro-
gramme is to be selected, check that there
is detergent in the detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop.
• The End indicator light comes on.
1. Switch off the dishwasher by returning
the programme knob to the Off position.
The On/Off indicator light goes off.
2. Open the dishwasher door, leave it ajar
and wait a few minutes before removing
the dishes; in this way they will be cooler
and the drying will be improved.
from the upper basket onto the dishes in
the lower one.
• Water may appear on the sides and the
door of the dishwasher as the stainless
steel will eventually become cooler than
the dishes.