Drying Cycle; Repeat (As Applicable); End Of Cycle; Selecting The Washing Program - Smeg SW260 Manual

Table's value are referred to machine working with 400V 3N~ electric and 55°C hot water supplies
and with no load inside.
If Repeat is enabled, leave the door slightly open after unloading the tableware if the machine is
not to be used again immediately; if the pause is very long, run a drain cycle first to prevent
foaming.
Some wash programs automatically run a quick hot water prewash.

5.9 Drying cycle

The drying cycle runs at the end of the wash program, see table of programs.
If the current program includes drying, the respective indicator light turns on.

5.10 Repeat (as applicable)

The Repeat function speeds up operation by reusing the last rinse water for the next wash.

5.11 End of cycle

Once the program has terminated, the display reads "End" alternating with the program code.
The "End" message only displays if all steps of the program have concluded successfully; it does not display if
the program has been paused, if a malfunction has compromised the result of the wash, or if the auto open
option is enabled.
The end of the signal is confirmed by a beep sounding.
SWT262
If auto open is enabled, the door opens automatically and 4 horizontal dashes display. Auto open is
not enabled if alarms occur during the program or if Repeat is enabled. The respective indicator light
turns on to confirm that the option has been enabled.
SWT260X
If the dry option has been enabled, the drying indicator light turns on: For programs which include
this option, the indicator light is:
1. Steady on when a program is running or has terminated successfully;
2. Flashing if drying is interrupted, during cooling, or at end of cycle due to a power failure or forced
interruption.

5.12 Selecting the washing program

To run a program:
1. If the dishwasher is off, turn it on with the On/Off button (hold down for 2 seconds).
2. Close the door by pressing it in until it clicks closed. The buttons are only enabled when the door is
closed.
3. Select the program with the selection buttons.
4. You can now view the nominal program duration by pressing the ON/OFF button.
5. To start the cycle press the Start/Pause button (hold down for 2 seconds).
6. The start of the cycle is confirmed by two beeps sounding.
7. Once the program has terminated, the display reads "End" alternating with the program code.
23