Clean Water Cycle" Option - Display Reads "Cl; Thermostop" Option - Display Reads "Ts; Fast/Eco Starting Option - Display Reads "Fi - Smeg UG405DUK Manual

7.10 "Clean water cycle" option - Display reads "CL"

7.11 "Thermostop" option - Display reads "tS"

7.12 Fast/eco starting option - Display reads "Fi"

When this option is activated, the appliance pumps out all the water
from the tank and then refills it with clean water at every wash cycle.
How long this operation takes depends on the washing water
temperature.
Press
"on" = the minimum temperature of rinse as set, independently from
the intake water temperature, the nominal duration of cycle may be
extended by a few seconds.
"off" = the minimum temperature of rinse may be a few degrees lower
than the set one, if hot intake water is not used.
Press
Fast (FS): it allows to start the machine in less time than the standard;
it involves a greater water consumption at the first start.
Eco starting (EC): the machine starts in standard time, without any
additional water consumption.
Press
17
to enable (On)/disable (OF)
to enable (On)/disable (OF)
to enable (On)/disable (OF)