Furuno VR3000 Instruction Manual page 18

6. After finishing the settings for one channel, click the Set button.
Note: Be sure to do this before moving another channel.
7. Repeat steps 2-6 to set up each channel.
When running Config Management for Tab Settings:
1. From the Maintenance menu, click VDR Config Management and then Config.
2. Click the Upload button to record data to the VDR memory.
3. Click the Write button to save data to the DRU, backup HDD and CF.
The buttons in the Setting Area are as follows:
Set:
Capture:
Select Equipment:
Reflect Equipment:
Check:
Individual Item Explanation:
Active*:
Brand:
Type No. (Equipment Name)*: Set type no. (equipment name)
Check*:
Data Name*:
Data Type:
Baud Rate:
Data Bit:
Parity Bit:
Stop Bit:
Source Checksum:
Time out:
Equipment Category*:
Board Name*:
Note*:
* Marked Items: For easy identification of input source, enter Equipment Category, Brand,
Type No., Date and Name.
Save edited data.
Received data shown in the serial window dialog box
Select equipment settings (saved to the database) to reflect in
a channel.
Save the equipment setting data to the database.
Check all channels. OK or NG (No Good) shown in
Information window.
Put check in check box to make channel active.
Enter brand name.
Do equipment check.
Enter data name.
Enter data type.
Set baud rate (Available for SI01 to SI08).
Set number of bits (Available for SI01 to SI08).
Set parity bit (Available for SI01 to SI08).
Set stop bit (Available for SI01 to SI08).
Enter checksum for GPS source.
Set time out.
Set equipment category.
Enter board names where channels are present.
Enter note.
16