Table of Contents
Advertisement
User Manual
iSiteC BTS3601C CDMA Base Station
MS
(9) Extended Supplemental Channel Assignment Message
Figure 3-4 Reverse SCH establishment procedure
1)
If the packet data call is established, MS may send "Supplemental Channel
Request Message" to BSC for establishing SCH channel.
2)
BSC sends "Abis-BTS Setup" to BTS for allocating radio resource for the call.
3)
After BTS establishes the channel, it sends "Abis Connect" to BSC.
4)
BSC responds with "Abis Connect Ack" to BTS.
5)
After BTS establishes all of the channels, it sends "Abis-BTS Setup Ack" to BSC,
indicating the completion of terrestrial circuit establishment.
6)
BSC sends "Abis-Burst Request" to BTS for activating BTS.
7)
BTS responds "Abis-Burst Response" message to BSC.
8)
BSC sends "Abis-Burst Commit" to BTS, and BTS starts to transmit SCH.
9)
BSC sends "Extended Supplemental Channel Assignment Message" and
assigns SCH channel for MS, so that the packet data service can be transmitted
at high speed in SCH channel.
3.2 Signaling Processing
BTS signaling processing serves to:
Implement interconnection of MS and BSS/CN on the air interface layer.
l
Perform part of radio resource management function under the control of BSC.
l
Specifically, BTS signaling processing performs the following functions: signaling
processing on Abis physical layer and transmission layer, channel resource
management, Abis traffic link management, BTS logic O&M processing, common
channel processing, dedicated channel establishment and release, traffic bearing and
power control.
BTS
(1) Supplemental Channel Request Message
(2) Abis-BTS Setup
(3) Abis Connect
(4) Abis Connect Ack
(5) Abis-BTS Setup Ack
(6) Abis Burst Request
(7) Abis Burst Response
(8) Abis Burst Commit
3-7
System Description
Chapter 3 System Function
BSC
Advertisement
Chapters
Table of Contents
