Bluetooth - Kenwood KMM-BT522HD Instruction Manual

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
– aptX codec (Qualcomm® aptX™) (for
Connect the microphone
MIC (microphone input terminal)*
Rear panel
Adjust the
microphone angle
* For the location of the microphone input terminal/microphone input jack, refer to page 38.
18
ENGLISH
/
Microphone
(supplied)
Secure using cord clamps
(not supplied) if necessary.
Pair and connect a Bluetooth device for the first time
1 Press to turn on the unit.
2 Search and select this unit model name (KMM-BT5**HD/
KMM-BT3**U/KMM-BT3**/KMM-BT2**U/KMR-M3**BT) on the
Bluetooth device.
"PAIRING" "PASS XXXXXX" Device name "PRESS" "VOLUME
KNOB" appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3 Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
)
Once pairing is completed, Bluetooth connection is established
automatically.
• /
"BT1" and/or "BT2" indicator on the faceplate lights up.
• /
lights up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain
registered in the unit even if you reset the unit. To delete the paired
device, 22, [DEVICE DELETE].
• A maximum of two Bluetooth phones and one Bluetooth audio device
can be connected at any time.
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. ( 23)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more
information.
/ /
: "BT1" and/or "BT2" on the display window
: