Zanussi ZRT53200SA User Manual page 21

If the doors are not opened and closed properly;
• Do the food packages prevent closing of the door?
• Are the door compartments, shelves and drawers placed properly?
• Are door gaskets broken or torn?
• Is your fridge on a level surface?
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer
during the operation of the compressor, this is normal.
IMPORTANT NOTES:
• The compressor protection thermal fuse will cutout after sudden power breakdowns
or after unplugging the appliance, because the gas in the cooling system is not
stabilised. This is quite normal, and the fridge will restart after 4 or 5 minutes.
• The cooling unit of your refrigerator is hidden in the rear wall. Therefore, water droplets
or icing may occur on the rear surface of your fridge due to the operation of the
compressor in specified intervals. This is normal. There is no need to perform a
defrosting operation unless the icing is excessive.
• If you will not use your fridge for a long time (e.g. in summer holidays), put the
thermostat to "•" position. After defrosting, clean your fridge and leave the door open
to prevent humidity and smell.
• If the problem persists after you have followed all the instructions above, please
consult to the nearest Authorised Service.
• The appliance you have purchased is designed for home type use and can be
used only at home and for the stated purposes. It is not suitable for commercial
or common use. If the consumer use the appliance in a way that does not comply
with these features, we emphasise that the producer and the dealer shall not be
responsible for any repair and failure within the guarantee period.
• The lifetime of your appliance stated and declared by the Department of the Industry
(the period for retaining parts required for the proper functioning of the appliance) is
10 years.
Conformity Information
• Tropical Class is defined for the environment temperatures between 16°C and 43°C
in accordance with the TS EN ISO 15502 Standards.
• The appliance is designed in compliance with the EN15502, IEC60335-1 /
IEC60335-2-24, 2004/108/EC standards.
EN - 19 -