Operation - Poulan Pro 115261126 Instruction Manual

KNOW YOUR PRUNER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
PRUNER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with
the location of the various controls and adjustments. Save this manual for future reference.
Pruner
Shaft
Extension Shaft
PRUNER
The PRUNER is designed for removal of
limbs and branches overhead not greater
than 6 inches (15 cm) in diameter.
OPERATING THE COUPLER
Your unit is equipped with a coupler system
which enables optional attachments to be
installed. The optional attachments are:
Edger . . . . . . . . . . . . . . . . . . . . .
Cultivator . . . . . . . . . . . . . . . . . .
Blower . . . . . . . . . . . . . . . . . . . .
Pruner . . . . . . . . . . . . . . . . . . . .
Brushcutter* . . . . . . . . . . . . . . .
*not designed for use with electric-powered
units.
WARNING:
Always stop unit and dis-
connect spark plug wire (or disconnect unit
from power source) before removing or instal-
ling attachments.
REMOVING PRUNER ATTACHMENT
(OR OTHER OPTIONAL ATTACH-
MENTS)
CAUTION:
When removing or installing at-
tachments, place the unit and attachment on
a flat surface for stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Attachment
TIGHTEN
2. Press and hold the locking/release button.

OPERATION

Chain
Bar
CHAIN TENSION
It is normal for a new chain to stretch during
first 15 minutes of operation. You should
check your chain tension frequently. See
CHAIN TENSION in the SERVICE AND AD-
JUSTMENTS section.
Locking/Release
Button
MODEL:
PPB1000E
Attachment
PPB2000T
PPB3000B
PPB5000P
3. While securely holding the engine end shaft
PPB4000C
and extension shaft, pull the attachment
straight out of the extension shaft coupler.
4. Repeat steps to remove extension shaft
from coupler on engine end shaft.
INSTALLING OPTIONAL ATTACH-
MENTS
CAUTION:
with other optional attachments.
1. Remove the shaft cap from the attachment
(if present) and discard.
2. Position locking/release button of attach-
ment into guide recess of coupler on engine
end shaft.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
LOOSEN
Knob
8
Hanger
Bar Oil Fill Cap
Bar Nut
Upper Shaft
Coupler
DO NOT use extension shaft
Coupler Primary Hole
Guide Recess
Locking/
Upper
Attachment
Release
Shaft
Button