Operation - Poulan Pro PP5000P Instruction Manual

7. Adjust the strap, allowing the hook to be
about 3 -- 6 inches below the waist.
8. Fasten the strap hook to the upper clamp
and lift the tool to the operating position.
Shoulder Strap
Shoulder
Strap
Clamp
KNOW YOUR PRUNER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
PRUNER ATTACHMENT. Compare the illustrations with your attachment to familiarize yourself with
the location of the various controls and adjustments. Save this manual for future reference.
Pruner
Tube
PRUNER
The PRUNER is designed for removal of
limbs and branches not greater than 4 inches
in diameter.
OPERATING THE COUPLER
Your powerhead is equipped with a coupler
which enables optional attachments to be
installed. The optional attachments are:
Edger . . . . . . . . . . . . . . . . . . . . . . .
Cultivator . . . . . . . . . . . . . . . . . . .
Blower . . . . . . . . . . . . . . . . . . . . . .
Brushcutter . . . . . . . . . . . . . . . . .
WARNING:
Always disconnect pow-
erhead spark plug (or disconnect powerhead
from power source) before removing or instal-
ling attachments.
ADJUSTING THE ASSIST HANDLE
WARNING:
sist handle, be sure it remains directly above
the coupler on the engine end tube to ensure
proper balancing of unit.
Coupler

OPERATION

Coupler
Bar oil fill cap
Chain
Bar
CHAIN TENSION
It is normal for a new chain to stretch during
first 15 minutes of operation.
check your chain tension frequently. See
CHAIN TENSION in the SERVICE AND AD-
JUSTMENTS section.
REMOVING PRUNER ATTACHMENT
(OR OTHER OPTIONAL ATTACH-
MENTS)
CAUTION:
When removing or installing at-
MODEL:
tachments, place the powerhead and attach-
PP1000E
ment on a flat surface for stability.
PP2000T
1. Loosen the coupler by turning the knob
PP3000B
counterclockwise.
PP4000C
7
When adjusting the as-
Assist Handle
Hanger
Bar nut
You should