Quick Reference Table - Supermicro A2SAP-H User Manual

Quick Reference Table

Jumper Description
FORCE POWER ON
JLCDPWR1
LVDS Panel Power Source Selection
Connector
BT1
I-SATA1
J3
J6
JCOM1
JDC
JEIO1
JF1
JGP1
JHDMI1
JLAN1/JLAN2
JMD1
JMP1
JPWR1
JSMBUS1
JUSB1
LVDS1
SRW1 ~ SRW2
Note: Components not documented are for internal testing only.
Description
Battery Connector
(To Clear CMOS, remove the battery, short pins 1-2 and install the battery.)
Intel® PCH SATA 3.0 Port
Front Panel Audio Header (Mic-In/Line-out)
Two USB 2.0 Headers
Two COM Headers (two RS232/422/485)
12V DC Jack Power Connector (for A2SAP-H)
Supermicro Extension I/O
(HDMI/DP, two PCI-E x1, two USB 2.0, LPC, SATA, SMBus, Power)
Front Control Panel Header (Power/HDD LED, Reset, Power button)
8-bit General Purpose I/O Header
High Definition Multimedia Interface (HDMI) Port
LAN1/LAN2 (RJ45 LAN) Ports
M.2 Slot (B-KEY 2242/3042) (SATA 3.0 / PCI-E / USB 2.0)
Mini PCI-E Slot (supports two PCIe Gen2 / one USB 2.0)
Two 4-pin 12V Power Connectors (for A2SAP-E/-L)
SMBus and 5V SATA Power Box Header
Two Back Panel USB 3.0 Ports
Dual Channel 48-bit LVDS Connector
M.2 and Mini PCI-E Mounting Holes
13
Chapter 1: Introduction
Jumper Setting (Default *)
Pins 2-4* (FORCE POWER ON)
Pins 4-6 (POWER BUTTON ON)
Pins 1-3* (3.3V)
Pins 3-5 (5V)