Advertisement
CAUTION: BEFORE PROCEEDING WITH PREPARATION OF TRACTOR:
•
Depress clutch/brake pedal fully and set parking brake.
•
Place gearshift/motion control lever in neutral (N) position.
•
Place attachment clutch in "DISENGAGED" position.
•
Turn ignition key "OFF" and remove key.
•
Make sure the blade and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
ON SOME MODEL TRACTORS, MINOR MODIFICATIONS MAY BE NECESSARY TO MOUNT YOUR NEW GRASS CATCHER. NOT
ALL MODEL TRACTORS WILL NEED THE FOLLOWING MODIFICATIONS. CHECK CARE FUL LY TO DETERMINE IF MODIFICATION
IS REQUIRED. ONCE YOUR MODEL TRACTOR CONFORMS TO THIS SECTION PRO CEED TO ASSEMBLY.
To Prepare your Grass Catcher you will need:
(1) Drill Motor
(1) 11/32" Drill Bit
DRILL HOLE IN MOWER DECK HOUSING (See
Fig. 12)
On some model tractors, it may be necessary to drill holes
in the mower deck housing. If your mower deck does not
have the holes. Drill two 11/32" holes as shown.
NOTE: To assist in proper hole location, there is a tem plate
in the back of this manual that may be used.
4-1/4"
1"
PREPARATION
DRILL HOLES
FIG. 12
NOTE
4"
1"
13
Advertisement
