Insignia NS-TWM41WH8A User Manual page 22

NS-TWM41WH8A_17-0655_MAN_V2_EN.fm Page 22 Friday, August 4, 2017 8:10 PM
3 If your washer is not level, carefully tilt your washer just enough to adjust the leveling feet on the bottom front
of your washer. Extend the feet only as much as is necessary. If the feet are extended too much, your washer
may vibrate.
Step 5: Power your washer
Plug the power cord into a well-grounded, 3-prong, 120 Volt 60Hz approved electrical outlet,
protected by a 15-amp fuse or comparable circuit breaker. Your washer is grounded through the
third prong of the power cord.
Step 6: Run a test cycle
Run a test cycle to make sure that your washer is properly installed.
1 Load about 6 pounds (2.7 kg) of laundry into the tub.
2 Press the /Power button to turn on your washer.
3 Turn the cycle selector to select the Rinse & Spin cycle.
4 Press the /Start Pause button to start the test cycle. Your washer should not rock or vibrate excessively when
water fills the tub, or when washing or spinning. The washer should drain well during the spin cycle.
Caution
• If you detect any water leaks while the washer is filling or draining, check
the water connections. See Step 2: Connect the water hoses on page 16
or Step 3: Connect the drain hose on page 19.
• If the washer rocks and/or vibrates excessively, level it again. See Step 4:
Level your washer on page 21.
22
INSTALLATION INSTRUCTIONS
Loosen
www.insigniaproducts.com
NS-TWM41WH8A
Level
Lock