Electrical Requirements - Insignia NS-TWM41WH8A User Manual

NS-TWM41WH8A_17-0655_MAN_V2_EN.fm Page 14 Friday, August 4, 2017 8:10 PM
Installing in an alcove or closet
Minimum clearances between your washer and adjacent walls or other surfaces are:
• Either side: 1 in. (2.5 cm)
• Rear: 6 in. (15.2 cm)
• Closet Front: 2 in. (5.1 cm)
• Top: 24 in. (61 cm)
• Gap between the end of water valve and the wall:
• Case 1: If you connect the supply hose after you install your washer: Over 3.9 in. (10 cm)
• Case 2: If you connect the supply hose before you install your washer: Over 2.8 in. (7 cm)
If you install your washer and dryer side-by-side in a closet, the closet front must have an unobstructed air opening
of at least 72 square inches (465 square cm).
1 in.
27 in. (68.6 cm)
2.5 cm

Electrical requirements

Warning
To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
Use a 120 Volt, 60Hz, 15 amp fuse or circuit breaker. We recommend an individual branch circuit that serves only
your washer.
Warning
Never use an extension cord.
Electrical grounding is required for your washer.
You must ground your washer. In the event of a malfunction or breakdown, grounding reduces the risk of electric
shock by providing a path of least resistance for the electric current.
Your washer is equipped with a power cord with a three-pronged grounding plug for use in a correctly installed
and grounded outlet.
14
1 in. 2 in.
2.5 cm 5.1 cm
29 in. (73.5 cm)
www.insigniaproducts.com
NS-TWM41WH8A
6 in.
(15.2 cm)