ESP 7 - Save these Instructions Desoutter Limited Eaton Road Hemel Hempstead Hertfordshire HP2 7DR England inattention while operating power tools may result in serious personal parts, and any other condition that may affect the tools operation. WARNING injury. If damaged, have the tool serviced before using. Many accidents are Dress properly.
Page 4
MAINTENANCE INSTRUCTIONS THREADTYP Note: When Controller Option Boards are used with the All servicing of the unit to be carried out by Desoutter ESP 7, the appropriate ESP 7 Programming Authorised Representatives. The 2 parameter allows the operator to prepare the system for Description for "Option 2, 3&4, or 5 must be used...
Page 5
ERROR 012 - EPROM error. To re-set ESP 7 after any of the above ERROR messages switch it * S Indicates programmed Final Speed in Non Current Mode, FA CTORY DEFA ULT "OFF" for a minimum of 15 seconds. (Note that the ESP 7 display C Indicates Programmed Current in Current Mode.
Page 6
ESP 7 - Option 1 Programming Description Desoutter Limited Eaton Road Hemel Hempstead Hertfordshire HP2 7DR England Explanation of status of Green "OK" LED on front of ESP 7. LED illuminates when the following conditions have been detected. Note: The following also applies to the External I/O "Cycle Completed"...
ESP 7 - Option 1 Programming Description ™ Desoutter Limited Eaton Road Hemel Hempstead Hertfordshire HP2 7DR England FUNCTION - PARAMETER CHANGE MODE: The Set-up and the Parameter Mode will both be exited automatically, if there is no user input for more than 60 seconds.