Siemens SIMOTICS XP 1LA5 Compact Operating Instructions page 11

3 Description
Additional languages in the Internet
You can find the operating instructions in other languages on the Internet page:
http://support.industry.siemens.com (Page 145)
If you require additional language versions, please contact the Siemens Service
Center (Page 145).
Intended use of the machines
These machines are intended for industrial installations. They comply with the
harmonized standards of the series EN / IEC 60034 (VDE 0530). It is prohibited that
these motors are used in hazardous zones if the marking on the rating plate does not
explicitly permit line or converter operation. If other/more wide-ranging demands (e.g.
protection so that they cannot be touched by children) are made in special cases –
i.e. use in non-industrial installations – these conditions must have been complied
with in the plant or system itself when the motors are installed.
Note
Machine directive
Low-voltage motors are components designed for installation in machines in
accordance with the current Machinery Directive. Commissioning is prohibited until it
has been absolutely identified that the end product is in conformance with this
Directive. Observe machinery directive EN 60204-1!
3.1 CE marking
Note
Use of machines without CE identification
Machines without
Economic Area (EEA). Do not use any machines without CE mark within of the EEA!
3.2 Regulations
The regulations and standards used as basis to design and test this machine are
stamped on the rating plate. The machine design basically complies with the
following standards:
Explosion-protected machines
56100000002002, 01/2016
marking are intended for operation outside the European
83