IKONNIK ET4 User Manual
4ch 2.4ghz xenon (xe) aw radio system
Hide thumbs
Also See for ET4:
- Owner's manual & technical information (26 pages) ,
- Quick start manual (4 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for IKONNIK ET4
Summary of Contents for IKONNIK ET4
- Page 1 User Manual of IKONNIK ET4 4Ch 2.4GHz Xenon (Xe) AW Radio System KNNS0002...
- Page 2 Basic data RX+TX Type Working frequency band 2405-2478MHz The shift number Item 94100 Distance Input voltage 6V DC Suitable model Model Car /Ship (mm) 147.30 Maximum Length Rx size (mm) 281.30 Maximum Height (mm) 128.26 Maximum Wide B. Appearance size...
- Page 3 C. Appearance picture D. Test method Diagram...
- Page 4 E. Instructions 1The code: Pressing the ‘PAIR’ button on the transmitter, Holding and switch on the transmitter, After power on release transmitter’s PAIR button, then press the ‘PAIR’ button on the receiver, the LED on the receiver should start flashing rapidly. And when the LED on the receiver become solid, that is, making the remote control code successfully.
- Page 5 adjust the angle on the right of the ST, increase or decrease. Pulling TH in the front in the end and do not move it, pressing CH2+ and CH2-, you can adjust the angle in the front of the TH, increase or decrease. Pulling TH at the behind in the end and do not move it, pressing CH2+ and CH2-, you can...
- Page 6 around 9 minutes, the buzzer will sounds continuously, and the LED should start flashing ，1 minutes later, the buzzer sounds long time once, that is , goes into the mode of dormancy, the LED goes out. 9. Warning of low voltage：Using the AA batteries or NIMH batteries, when the voltage is lower than 4.5V ±0.2, the buzzer sounds continuously, and the LED should start flashing.
- Page 7 Waiting for 5 seconds after the lights flash once, and clear the current memory beep, wait 5 seconds and then continue to hold the rear lights flash twice and will beep twice, indicating recovery to the factory settings. All memories will be clear. Wait for 5s (1beep/flash)=Model reset;...
- Page 8 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.