IKONNIK ET4 User Manual page 4

E. Instructions
1The code: Pressing the 'PAIR' button on the transmitter,
transmitter, After power on release transmitter's PAIR
button on the receiver, the LED on the receiver should start flashing rapidly. And when
the LED on the receiver become solid, that is, making the remote control code
successfully.
Note: All transmitters and receiver is already paired OK when they delivery, If user
Missed them or want to repaired again, They can operated above.
2. Trim: Keeping the trigger and
CH1-, CH2 +, CH2- --- adjust to the center position of the ST/TH.
3. Adjust D/R: Switch on the transmitter , Pressing ST D / R +
the angle of CH1.
4. Adjust EPA: Pulling ST to the left in the end and do not move it, pressing CH1+ and
CH1-, you can adjust the angle on the left of the ST, increase or decrease.
Pulling ST to the right in the end and do not move it, pressing CH1+ and CH1-, you can
turnning wheel is less than 50%
Holding and switch on the
button, then press the 'PAIR'
fixed. Press the CH1 +,
or ST D / R- . You can adjust