IKONNIK ET4 User Manual page 5

adjust the angle on the right of the ST, increase or decrease.
Pulling TH in the front in the end and do not move it,
adjust the angle in the front of the TH, increase or decrease.
Pulling TH at the behind in the end and do not move it,
adjust the angle at the behind of the TH, increase or decrease.
5. adjust REV:
Pulling ST to the right or to the left in the end and do not move, pressing the REV about 5
seconds that is the reverse in the direction of ST.
Pulling TH to the forward or to the backward in the end and do not move, pressing the
REV about 5 seconds ,that is the reverse in the direction of TH.
When you do nothing with the transmitter, press the button REV, that's the reverse of the
channel CH4.
6. Fail safe function setting: Pulling the trigger to the front or at the behind of the position
you want, keep it fixed, pressing button CH4 about 5 seconds, then the buzzer will sounds
one time. loosen CH4 about 1-2 seconds, then loosen the trigger of TH, close the switch
of the transmitter. The throttle channel of the receiver will go into the mode of fail safe
function.
7. Operate CH3: The channel CH3 is linear, you can use CW or CWW to control.
8. Automatic dormancy：The transmitter is at the state of static, there is no operation,
pressing CH2+ and
pressing CH2+ and
CH2-, you can
CH2-, you can