IKONNIK ET4 User Manual page 7

Waiting for 5 seconds after the lights flash once, and clear the current memory beep, wait
5 seconds and then continue to hold the rear lights flash twice and will beep twice,
indicating recovery to the factory settings. All memories will be clear.
Wait for 5s (1beep/flash)=Model reset;
Wait for 10s(2beeps/flashes)=Factory reset
13. Beginning switch: The beginning switch has 3 positions, 1 is STANDARD MODE, This
mode that all functions are well, all key operate as normal. 2 is LOCK mode, This mode
that all functions are well, but only can operate ST TRIM button, other key cannot be
operate. 3 is BEGINNER MODE, This mode that all functions are well, only can operate ST
TRIM button other key cannot be operate and TH forward Speed will cut 50%
Notice
1. The transmitter with Fail safe function , when the signal is lost, the accelerator will
automatically at a set position, please do not pick Fail safe function device.
2. Function setting mode into DC6V±0.1 voltage test.
3. In sleep mode, the transmitter power off automatically, re-switch on transmitter, the
functions will be exit.
.