Section 5 − Installation; Power Source And Wire Feeder Site Selection - Miller Continuum Owner's Manual

5-1. Power Source And Wire Feeder Site Selection

Movement
1
Location And Airflow
18 in.
(460 mm)
SECTION 5 − INSTALLATION
!
OR
2
Do not put feeder where
welding wire hits cylinder.
3
18 in.
(460 mm)
!
Do not move or operate
unit where it could tip.
!
Special installation may be required
where gasoline or volatile liquids are
present − see NEC Article 511 or CEC
Section 20.
!
Do not move or operate equipment
where it could tip.
1 Hand Cart
Use cart or similar device to move unit.
2 Lifting Forks
Use lifting eye or lifting forks to move unit.
If using lifting forks, extend forks beyond
opposite side of unit.
3 Line Disconnect Device
Locate unit near correct input power supply.
Loc_contfeeder 2015-07
OM-266409 Page 13