Table of Contents
Advertisement
DCRS-7600 InstallManual
To avoid damage, do not place any weight on the switch.
2.6.1.2 Rack-mounting DCRS-7600 series.
Note:
Before mounting the DCRS-7600 series into the rack, verify that the mounting
positions of the rack are correct. Preposition of the mounting points may result in
inadequate spacing between the switch front panel and the rack front door, and the
rack front door may be unable to be closed with cables and fiber cables connected.
Please keep a 10 mm spacing between the switch front panel and the rack front door.
Verify the following before installation: the rack is stably positioned; all modules
inside the chassis are fully installed; no obstructions are present inside or around the
rack; the switch is situated near the rack for ease of installation.
Installation Steps
Step 1: Attach the 2 hangers on the DCRS-7600 series with screws provided in the
accessory kit.
Be sure to attach the hangers in the correct direction, otherwise the switch
will not be able to mount into a standard rack.
Note that the hangers are not weight bearing. They are used to fasten the
switch. The mounting Shelf or sliding rails (bolt to the rack) will support the
switch.
The
hangers:
Fig 2-1 Installing DCRS-7604 Switch Hangers
figure
below
shows
2-9
Chapter 2 Hardware Installation
the
steps
for
mounting
the
Advertisement
Table of Contents
