Table of Contents
Advertisement
Configuring the Power Cue Store
To enter configuration mode, the Power Cue Store must be receiving DMX data.
After verifying that DMX data is being sent, press the CONFIG switch using a thin
screwdriver or similar device. The display shows CnF.
This mode allows you to adjust the following:
o
o
o
Press SCENE TYPE at any time to toggle between the three options above.
Press ESC to exit configuration mode.
Global Fade Time
Press SCENE TYPE until FAd appears in the display, followed by the current
global fade time, in seconds.
The slider LED flashes to prompt you to input a value. Move the slider to adjust the
fade value between 0-0.9 seconds and 1-99 seconds, then press STORE.
The display then shows YES, then the new global fade time.
Global Hold Time
To set the global hold time, do one of the following:
o
o
The slider LED flashes to prompt you to input a value.
Move the slider to adjust the hold value between 0-0.9 seconds, 1-59 seconds and
1-30 minutes, then press STORE.
The display then shows YES, then the new global hold time.
To avoid confusion when setting fade and hold times, note the following:
00.1 = one tenth second.
01.0 = one second
1. = one minute
Loss of Data Key
The Loss of Data key setting determines what happens when DMX data is lost. To
set the Loss of Data key, do one of the following:
o
o
Choose one of the following four keys:
o
Page 6
Global fade time
Global hold time
Loss of data key
Press ESC (which exits configuration mode)
Press SCENE TYPE until Hld appears in the display
Press ESC (which exits configuration mode)
Press SCENE TYPE until Lod appears in the display
For stand-alone operation, select Lod 3. This holds the currently selected
scene. The display shows the scene number on loss of data.
Power Cue Store
TM
TM
User Manual
Advertisement
Table of Contents
