Chase Sequences; Return To Pass-Through Mode - High End Systems Power Cue Store User Manual

Moving the slider causes the Power Cue Store to fade from the current scene to the
next valid scene at the speed that you move the slider. The display flashes
alternately the number of the current scene and the next scene.
The slider indicates that a fade is in progress by flashing its LED when the slider
value is between 10% and 90%.
Moving Between Scenes with the Keypad
Enter the number of the scene to which you want to fade. The display flashes
alternately the number of the current scene and the desired scene. During the fade
the slider flashes to show that it is active.
Pre-programmed Fade and Hold times are ignored. When the last programmed scene
or scene 63 is accessed, the next fade will be to scene 1.

Chase Sequences

When a start-of-chase scene (SoC) is encountered, a chase starts to run according to
pre-programmed Fade and Hold times.
Deleted or empty scenes are ignored. The chase continues until an end-of-chase
scene (End) is encountered. The chase then loops back to the SoC scene.
To stop a chase and pass to the next scene outside the loop, use the slider or press
AUTO. During a chase the display shows only the number of the first scene in the
chase.
The slider LED flashes slowly to indicate that a chase is running.

Return to Pass-Through Mode

You can return to pass-through mode only when DMX data is being received, as
indicated by a dot in the right of the display. (If no DMX data is being received,
Power Cue Store remains in manual mode.)
Press TAKE CONTROL to return to pass-through mode.
Page 10
TM
Power Cue Store User Manual