Resetting The Scene To Default Values; Deleting The Scene; Flagging The Scene As The First In A Sequence; Flagging The Scene As End Of A Sequence - High End Systems Power Cue Store User Manual

Resetting the Scene to Default Values

To reset the scene back to default values:
1.
2.

Deleting the Scene

To delete the scene:
1.
2.
Flagging the Scene as First in a Sequence
To designate the scene as the first scene in a sequence:
1.
2.

Flagging the Scene as End of a Sequence

To designate the scene as the last scene in a sequence:
1.
2.

Pass-Through Mode

Pass-through mode is indicated by a dot in the right hand element of the display. In
pass-through mode, DMX data is received, and the Power Cue Store is inactive.

Manual Control

Manual control is indicated by a dot in the center of the display.
If the DMX signal is lost, Power Cue Store automatically enters manual mode and
responds according to the Loss of Data key, as discussed in the section "Loss of
Data Key".
Alternatively, you can enter manual mode mode by pressing the TAKE CONTROL
button. The Power Cue Store then outputs the scene shown in the display until it
receives a command.

Moving Between Scenes with the Auto Button

If the AUTO button is pressed, the Power Cue Store steps to the next valid scene. If
any other scene is selected, the display will flash alternately the number of the
current scene and the number of the next-selected scene.
Press AUTO to step to the next-selected scene.
Any programmed Fade time is processed, but Hold times are ignored. When the last
programmed scene or scene 63 is accessed, the next step will be to scene 1.

Moving Between Scenes with the Slider

Press SCENE TYPE until rST appears in the display.
Press STORE until YES appears in the display.
Press SCENE TYPE until dEL appears in the display.
Press STORE until YES appears in the display.
Press SCENE TYPE until Soc appears in the display.
Press STORE until YES appears in the display.
The scene is designated as the start-of-chase scene (SoC).
Press SCENE TYPE until End appears in the display.
Press STORE until YES appears in the display.
The scene is designated as the end-of-chase scene (End).
Power Cue Store
TM
User Manual Page 9