Service Position; Wire Dressing - Sony KD-32DX150U Service Manual

2-8. Service Position

To place the chassis in the service position, remove the G1
and D2 brackets and position on the side of the main bracket
as shown above. Insert the main bracket firmly into the T-slot
located on the left corner of the beznet as indicated (see inset).
To gain access to the underside of the boards follow the
instructions on page 20. [Removal and Replacement of the
main bracket bottom plates].

2-10. Wire Dressing 2

The sheathed end of the ground connecting lead must be
plugged into the F board to avoid the possibility of the AC
mains power touching ground.
2-9. Wire Dressing 1
To avoid damage to the ground interconnecting leads from the
sharp edges of the heatsink they must be dressed as shown
above between the rear of the heatsink and the tuner.
2-11. Wire Dressing 3
Ensure that wires do not touch heatsinks and high temperature
hotspots. All wires must be kept at a minimum distance of
20mm away from the EHT lead
- 18 -
20mm
20mm