Related Manuals for Wilson Electronics MobileMaxx 3G 460011
Summary of Contents for Wilson Electronics MobileMaxx 3G 460011
- Page 1 MobileMaxx 3G ™ Cellular Signal Booster 460011 Need help? www.WilsonElectronics.com Tech Support 866-294-1660 Mon.- Fri. Hours: 7 am to 6 pm MST...
-
Page 2: Table Of Contents
RISK TO THE VEHICLE . AGAIN, BE SURE TO PLACE YOUR SIGNAL BOOSTER IN A LOCATION WITH ADEQUATE VENTILATION AND AWAY FROM DIRECT SUNLIGHT OR MOISTURE . Installation Instructions for the Following Wilson Electronics Signal Boosters: MobileMaxx 3G SmarTech Signal Booster ™... -
Page 3: Package Contents
Package Contents Kit Configuration Wilson Electronics manufactures a wide variety of antennas to help you customize your Signal Booster for your specific application . See your dealer or visit www.WilsonElectronics.com for more information . 12” Mag Mount Slim Low Profile... - Page 4 • At least 8 inches from any people. Place and connect the MobileMaxx 3G Signal Booster . The Outside Antenna must be installed vertically on a metallic • Select a location for the Signal surface . Booster that is free from excessive heat, direct sunlight and moisture and that has proper ventilation .
-
Page 5: Understanding The Lights
. mobile device and the Inside Antenna until the light is no longer flashing red. Contact Troubleshooting & Wilson Electronics Technical Support Team Understanding Lights for assistance . The lights on the top of the Signal Booster indicate whether the system is working or if there are problems . - Page 6 Mobile Antenna Kit Options Fixed Antenna Kit INSIDE ANTENNA OPTIONS Kit 301151-1110 • 75 Ohm Dome Antenna Options Slim Low Profile • 10’ RG11 cable 301152 - w/ 10’ RG174 Kit 311155-1150 INSIDE ANTENNA OPTIONS • 75 Ohm Wall mount Panel Low Profile Kit 309900-50N Antenna...
-
Page 7: Safety Guidelines
This device complies with Part 15 of FCC rules . Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation . Changes or modifications not expressly approved by Wilson Electronics could void the authority to operate this equipment . - Page 8 Notes: _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ _____________________________________________________________ Need help? www.WilsonElectronics.com Tech Support 866-294-1660 Mon.- Fri. Hours: 7 am to 6 pm MST...
-
Page 9: Signal Booster Specifications
Signal Booster Specifications MobileMaxx 3G Model Number 460011 Connectors Antenna Impedance 50 Ohms Frequency 824-894 MHz and 1850-1990 MHz 800 MHz 1900 MHz Passband Gain (nominal) 47 .8 44 .2 800 MHz 1900 MHz 20 dB Bandwidth (MHz) Typical 37 .8 79 .4 Maximum 39 .4... - Page 10 Returned Material Authorization (RMA) number supplied by Wilson Electronics . Wilson Electronics shall, at its option, either repair or replace the product . Wilson Electronics will pay for delivery of the repaired or replaced product back to the original consumer if located within the continental U .S .
Need help?
Do you have a question about the MobileMaxx 3G 460011 and is the answer not in the manual?
Questions and answers