Installation/ Connection Specifications - Kenwood KDC-X702 Instruction Manual

REFERENCES
Source name
iPod 1/iPod 2/iPod USB/ When [MODE OFF]/[BROWSE MODE] is selected ( 11):
iPod BT or ANDROID 1/ Song title (Artist)
ANDROID 2/ANDROID Playing time (Date)*
PANDORA 1/ Station name (Date)*
PANDORA 2/PANDORA/ (Artist) Song title (Album title)
PANDORA BT Playing time (Date)*
IHEARTRADIO 1/ Station name (Date)*
IHEARTRADIO 2/ (back to the beginning)
IHEARTRADIO
SPOTIFY 1/SPOTIFY 2/ Context title (Date)*
SPOTIFY/SPOTIFY BT (Album name)
(back to the beginning)
SIRIUS XM Channel number (Status)
Artist name (Status)
(Status) Category name (Status)
(back to the beginning)
BT AUDIO Song title (Artist)
Playing time (Date)*
AUX Source name (Date)*
* Battery and signal strength of the Bluetooth device will be shown if [BATTERY/SIGNAL] is
set to [AUTO]. ( 24)
Display information
Song title (Album name) Song title (Date)*
(back to the beginning)
Shared/Radio station (Date)* Song title
Song title (Date)*
(back to the beginning)
Song title (Artist) Song title (Date)*
Song title (Artist) Song title
Song title (Date)* Playing time (Date)*
Channel name (Status)
Song title (Status) Content information
Date (Status)
Song title (Album name) Song title (Date)*
(back to the beginning)
INSTALLATION/CONNECTION
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short-circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that come into
contact with metal parts to protect the wires.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
39
ENGLISH