Table of Contents
Advertisement
OPENING AcOustIc cOllAr ZIPPEr VOIDs WArrANtY!
The electronic components inside the Acoustic Collar of the
SRC-System are closed by a sealed zipper. Please do not tamper
with or open the zipper as this will void your warranty.
11. NOTICES
federal Communications Commission (fCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by
the part responsible for compliance could void the user's authority to operate
the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
36
QG SRC 131 - QG0160.indd 36
IMPORTANT:
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may
cause undesired operation of the device.
fCC Rf Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating in-
structions for satisfying RF exposure compliance. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada (IC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by
the part responsible for compliance could void the user's authority to operate
the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the IC rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
10/20/09 11:29 AM
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SRC System and is the answer not in the manual?
Questions and answers
How do you change language from German to English on the SRC system
To change the language from German to English on the SCHUBERTH SRC System:
1. Make sure the headset is on standby.
2. Press and hold both the CHANNEL “A” and CHANNEL “B” buttons at the same time for 3 seconds.
3. The voice menu will start.
4. Follow the voice instructions to select English as your preferred language.
This answer is automatically generated