Table of Contents
Advertisement
NOTE: While the Intercom is on, the Redial and Voice Dial functions will
be disabled.
9.7 enable/DIsable VoICe ConneCT feaTURe (VoX)
The SRC-System also offers VOX technology for safe and hands-free
operation of some key functions.
For incoming calls, just pronounce loudly any word (e.g. "hello"). To
reject an incoming call, you need only to remain silent for about 15
seconds. To reject an intercom call remain silent for 30 seconds.
While on standby press and hold the Volume Up and Volume Down
Buttons simultaneously for three seconds until you hear a beep. The
default status is Voice Connect enabled.
NOTE: The Enable/Disable Voice Connect feature affects only the Inter-
com functionality.
9.8 ReseT PaIRInG (ResToRInG THe oRIGInal DefaUlT
ConfIGURaTIon)
This section is only relevant once you have completed a pairing process
You can delete all of your paired devices at any time as follows:
1. With the SRC-System headset turned ON, press and hold the
Mobile Button for at least six seconds until the Red and Blue Lights
begin rapidly alternating.
2. Press and hold the Volume Up Button for three seconds.
3. The Red and Blue Lights will flash five times simultaneously and
then the headset will turn off, confirming that Reset was success-
fully completed.
9.9 noTeWoRTHY IssUes
a. busy Status (when using a sRC-system headset)
When attempting an Intercom call with a headset that is already on
a Phone/ GPS/ Intercom call, you will hear two beeps indicating the
other headset is busy.
QG SRC 131 - QG0160.indd 35
b. automatic Reconnection of the Intercom
If the SRC-System and another paired headset go out of range and
disconnect from each other, the SRC-System will immediately try to
reconnect to the other headset.
You can manually reconnect the intercom call while the headset is in
Standby mode by pressing the CHANNEL "A" or the CHANNEL "B" But-
ton to connect to the respective lost connection.
c. Conference Mode limitations
Whenever you enter the Intercom Conference mode among three
participants (including yourself), the participants who maintain
simultaneously two active connections will not be able to receive
mobile phone calls or GPS messages as long as the conference call is
in progress (see details in sections 9.4 b).
9.10 TRoUblesHooTInG THe InTeRCoM
First, make sure your microphone is located properly in front of the
center of your mouth.
The SRC-System is designed for use in loud environments. Therefore,
you should test the Intercom functionality only in a noisy environ-
ment, such as next to an idling motorcycle and not indoors. Please
also verify that the headsets were paired together properly by follow-
ing the instructions in the relevant Setup sections.
10. SUPPORT
For additional information please visit our website at
www.schuberth.com
For technical support please contact us at:
support@src-system.com
Phone: +49-391-8106-444
For the latest information on firmware upgrades please visit our
website at www.src-system.com and register on-line.
35
10/20/09 11:29 AM
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SRC System and is the answer not in the manual?
Questions and answers
How do you change language from German to English on the SRC system
To change the language from German to English on the SCHUBERTH SRC System:
1. Make sure the headset is on standby.
2. Press and hold both the CHANNEL “A” and CHANNEL “B” buttons at the same time for 3 seconds.
3. The voice menu will start.
4. Follow the voice instructions to select English as your preferred language.
This answer is automatically generated