Enabling And Disabling Parksense; Engagement/Disengagement - Jeep CHEROKEE 2018 User Manual

NOTE:
If your vehicle is equipped with the
ParkSense Active Park Assist system, six sen-
sors will be located in the rear fascia/bumper.
Refer to the "ParkSense Active Park Assist
System" section for further information.
The six ParkSense sensors, located in the
front fascia/bumper, monitor the area in front
of the vehicle that is within the sensors' field
of view. The sensors can detect obstacles
from approximately 12 inches (30 cm) up to
47 inches (120 cm) from the front fascia/
bumper in the horizontal direction, depend-
ing on the location, type and orientation of
the obstacle.

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
156
ParkSense Switch
When the ParkSense switch is pushed to disable
the system, the instrument cluster display will
show the "PARKSENSE OFF" message for ap-
proximately five seconds. Refer to "Instrument
Cluster Display" in "Getting To Know Your Instru-
ment Panel" in your Owner's Manual at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca
(Canadian Residents) for further information.
When the gear selector is moved to REVERSE
and the system is disabled, the instrument
cluster display will show the "PARKSENSE
OFF" message for as long as the vehicle is in
REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service.
The ParkSense switch LED will be off when
the system is enabled. If the ParkSense
switch is pushed, and requires service, the
ParkSense switch LED will blink momen-
tarily, and then the LED will be on.

Engagement/Disengagement

To disengage the system, push the ParkSense
switch, located on the switch panel below the
Uconnect display.
When the system passes from engaged to
disengaged and vice versa, it is always ac-
companied by a dedicated message in the
instrument cluster display.
System engaged: ParkSense switch LED off.
System disengaged: ParkSense switch LED on
constantly.