Configure The Dfnt Module - ProLinx 6201-WA-ASCII Setup Manual

Configure the DFNT Module

4 Configure the DFNT Module
In This Chapter
Based on the sample application, the remote Server is connected to a 6201-WA-
DFNT configured as a Client. The goal here is to begin to establish
communications between the 6201-WA-ASCII and 6201-WA-DFNT modules.
The default configuration is designed to pass 1200 words between each module.
Each module is configured separately.
Configuration is accomplished using ProSoft Configuration Builder (PCB). The
default configuration file is PROLINX WIRELESS SAMPLE.PPF.
Start PCB.
1
Select File → Open.
2
Navigate to the location where you copied the PROLINX WIRELESS
3
SAMPLE.PPF file and select this file.
Expand the ASCII Serial to EtherNetIP folder.
4
Expand the 6201-WA-DFNT module selection.
5
ProSoft Technology, Inc.
September 6, 2007
Complete the ProSoft Configuration Builder Sections............ 24
Save and Download the Configuration File to the 6201-WA-DFNT
............................................................................................... 32
6201-WA-ASCII ♦ ProLinx Wireless
High Speed Wireless ASCII Generic Serial Gateway
Page 23 of 50