Table of Contents
Advertisement
5. U
Chapter 5 provides an introduction to using the TCP/IP features
on your BL2000 board.
5.1 TCP/IP Connections
Before proceeding you will need to have the following items.
• If you don't have Ethernet access, you will need at least a 10Base-T Ethernet card
(available from your favorite computer supplier) installed in a PC.
• Two RJ-45 straight through Ethernet cables and a hub, or an RJ-45 crossover Ethernet
cable.
The Ethernet cables and Ethernet hub are available from Z-World in a TCP/IP tool kit.
More information is available at www.zworld.com.
1. Connect the AC adapter and the programming cable as shown in Chapter 2, "Getting
Started."
2. Ethernet Connections
If you do not have access to an Ethernet network, use a crossover Ethernet cable to con-
nect the BL2000 to a PC that at least has a 10Base-T Ethernet card.
If you have Ethernet access, use a straight through Ethernet cable to establish an Ethernet
connection to the BL2000 from an Ethernet hub. These connections are shown in Figure 21.
User's PC
Ethernet
crossover
cable
Direct Connection
(Network of 2 computers)
User's Manual
SING THE
BL2000
Board
Ethernet
cables
Direct Connection Using a Hub
Figure 21. Ethernet Connections
TCP/IP F
BL2000
Board
Hub
EATURES
To additional
network
elements
51
Advertisement
Table of Contents
