Table of Contents
Advertisement
The PC running Dynamic C through the serial programming port on the BL2000 does not
need to be the PC with the Ethernet card.
3. Apply Power
Plug in the AC adapter. The BL2000 is now ready to be used.
NOTE: A hardware RESET is accomplished by unplugging the AC adapter, then plug-
ging it back in, or by momentarily grounding the board reset input at pin 9 on screw ter-
minal header J2.
When working with the BL2000, the green
the board is properly connected either to an Ethernet hub or to an active Ethernet card. The
orange
light flashes each time a packet is received.
ACT
52
light is on when a program is running and
LNK
Wildcat (BL2000)
Advertisement
Table of Contents
