Preparing The Stud Welding Gun; Mounting The Chuck - HBS CI 03 Operating Manual

10 Preparing the Stud Welding Gun

10 Preparing the Stud Welding Gun
Prepare the stud welding gun by

– mounting the chuck

– adjusting the spring force.
‹ Do not connect the stud welding gun to the stud welding unit until it
has been prepared.
In this way you can avoid any unintentional starting of the welding process.
10.1 Mounting the Chuck
‹ Select a chuck suitable for your welding element.
Cupped head pin
18
Cupped head pin dimension
Ø in mm
30
28
‹ Loosen the retaining nut.
‹ Put the chuck with loose retaining nut up to the
stop into the piston of the welding gun.
‹ Tighten the retaining nut again with the double
open ended wrench AF 14/17.
‹ Insert the spacer (tripod).
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
Chuck (with solenoid)
82-50-310B
82-50-308A