Fitting Sfp Connectors; Basic Connections - Optical Systems Design OSD2153P Operator's Manual

2.2.7

FITTING SFP CONNECTORS

Care should be taken when inserting/removing the SFP connectors from the SFP port as SFP modules
are Electrostatic (ES) sensitive and Electrostatic Discharge (ESD) precautions should be taken when
installing. Ensure that the SFP is fully engaged and latched into position.
Inserting SFP – Ensure that the SFP lever is in the locked position and insert into appropriate SFP
port. Gently push the SFP until it locks into place. Remove plastic/rubber dust cap and fit appropriate
fiber cable.
Removing SFP – Remove fiber connector. Pull the SFP lever down to unlock SFP from housing.
Using the lever, gently pull the SFP out.
Fiber SFP
FIGURE 9: FITTING/REMOVING SFP CONNECTORS
2.2.8

BASIC CONNECTIONS

Figure 10 shows basic user connections to the OSD2153P.
LC Fiber cable
Ethernet cable
PAGE 14
OPTICAL SYSTEMS DESIGN
Inserting
SFP
Power
FIGURE 10: BASIC CONNECTIONS
OSD2153P OPERATOR MANUAL
2
1
Removing
SFP
Chassis Ground
DOC ID: 10115804