Ais (Output Ais); Aomerge (Automatic Output Merge) - Symmetricom TimeHub 5500 Reference Manual

Keywords
Keyword Description
Note: This feature is available in firmware versions 4142B and later.
If a manually set output SSM value is selected, ACTSSM does not
report the manually set SSM value (see
SSM), on page 124 and
124). Instead, ACTSSM reports the SSM value that would be applied
if the manual capability was disabled.

AIS (Output AIS)

This keyword forces an Output Driver card to generate AIS instead of the usual
formatted signal. The keyword format is:
AIS=<value>
Parameter
<value>

AOMERGE (Automatic Output Merge)

This keyword specifies if the automatic output messages and commands are
carried separately on two different communication ports or combined on one port.
The network parameters for the two ports are: PORTCMDS and PORTAO. The
keyword format is:
AOMERGE=<value>
Parameter
<value>
If the IP address of the manager matches IPLM1 or IPLM2 the output is merged
regardless of the AOMERGE value.
Following a firmware download to the Management card, AOMERGE can be reset
to N. If one port had been used to carry both automatic events and commands, the
AOMERGE setting should be checked and changed to Y if necessary.
94 TimeHub 5500 TL1 Reference Guide
OQLEVEL (Output Quality
Value
Y Output Driver card generates AIS
N Output Driver card generates framed data
Value
Y Messages and commands are carried combined on
one communication port
N Messages and commands are carried separately on
two different communication ports
OMANSSM (Output Manual
Level), on page
Description
Description
097-55501-02 Issue 7 – January, 2005