Table of Contents
Advertisement
X5669WUP3 User's Manual
Version 1.0
Call Waiting (CW) enables a busy customer to be notified of a
new incoming call that is in a waiting position. This feature
must be provisioned to disabled. The customer has the choice
to enable this service.
The customer then has the choice of accepting, rejecting or
ignoring the waiting call, making use of switching orders
based on R.
When the user presses R (hook flash) a new dial tone shall
be sent to the customer.
3.3.1 Call Waiting customer configuration
Activation: * 43 #
Deactivation: # 43 #
Call Waiting is permanently enabled or disabled until disabled
/ enabled again. E.g. not on a per call basis. These setting
shall survive a reboot, reconfiguration, software upgrade and
any other imaginable actions that can be performed with the
ATA.
3.3.2 Force Busy
To reject the new call without answering it: R (dial tone) 0. The
CPE will send a Busy signal to the calling party.
R0 shall also temporarily deactivate the call waiting service
for the rest of the active call. When the subscriber hangs up
the service shall automatically be activated again.
62
Advertisement
Table of Contents
