Table of Contents
Advertisement
X5669WUP3 User's Manual
VII. Management
There are several ways that you can make the configuration:
Local Ethernet Port (telnet) – connect the Ethernet port to your
local area network or directly to a PC, "telnet" X5668 from any
workstation in the LAN. The default local Ethernet IP address is
"192.168.1.1". See Chapter 2, Command Line Interface, for more
details.
Local Ethernet Port (Web browser) – connect the Ethernet port
to your local area network or directly to a PC. Launch your Web
browser and enter default local Ethernet IP address "192.168.1.1"
into the address bar.
ADSL Port from Remote Site – while the ADSL connection is in
service and it is set to router mode, you may remotely "telnet"
X5668 from a workstation connected to the equipment.
Note: As operating an ADSL device requires technical know-how and
experience, it is recommended that only qualified technical staff manage
X5668 Therefore, a password authentication is required when you enter
the command line and Web interface. See the Default Values section to
obtain the password.
8
Version 1.0
Advertisement
Table of Contents
