Controls
Height
Adjust the head restraint so that its centre is ap‐
proximately at the height of your ear.
Adjust height
▷
Up: pull
▷
Down: press the button, arrow 1, and slide
the head restraint downwards.
The height of the centre head restraints cannot
be adjusted.
Removing
Only remove the head restraint if no-one will be
sitting on the seat in question.
1.
Pull up the head restraint until it stops.
2.
Press the button, arrow 1, and pull the head
restraint fully out.
Before carrying passengers
Install the head restraints again before
carrying passengers, otherwise the head re‐
straints do not offer protection.◀
50
Adjusting
Online Edition for Part no. 01 40 2 900 867 - 03 12 490
Seat and mirror memory
General
You can save and recall two different positions
for the driver's seat and exterior mirrors for each
remote control. Settings for backrest width and
lumbar support are not saved.
Saving
1.
Switch on ignition.
2.
Set desired position.
3.
Press the button. LED in button is
illuminated.
4.
Press the desired button 1 or 2. LED turns
off.
If the M button was pressed accidentally:
Press the button again.
LED turns off.
Recalling
Do not call up the memory while the vehi‐
cle is in motion
Do not call up the memory while the vehicle is in
motion, otherwise an unexpected seat or steer‐
ing wheel movement may cause an accident.◀
Convenience function
1.
Open the driver's door.
2.
Switch the ignition off.
3.
Briefly press button 1 or 2 as desired.