Interior Equipment - BMW X3 xDrive20i 2013 Owner's Handbook Manual

Interior equipment

Vehicle Equipment
This chapter describes all standard, national and
special equipment provided in the model series.
Therefore equipment not available in a vehicle is
also described, for example the selected special
equipment or national version. That also applies
to safety-relevant functions and systems.
Integrated universal remote
control
Principle
With the integrated universal remote control, up
to 3 functions of radio-controlled systems, for
example, garage door drivers or lighting sys‐
tems, can be operated. The integrated universal
remote control thereby replaces up to 3 different
hand-held remotes. For operation, the buttons
on the interior mirror must be programmed with
the desired functions. The relevant system is
needed to program the hand-held remote.
During programming
During programming and before a system
is operated with the integrated universal remote
control, make sure that no persons, animals or
objects are within the swivelling or movement
range of the system in question, as otherwise
injury or damage could result.
Also follow the safety instructions supplied with
the hand-held transmitter.◀
Before you sell the vehicle, delete the saved
functions beforehand for your own security.
Compatibility
If this symbol is depicted on the pack‐
aging or in the instruction manual of the
system to be operated, this is usually
compatible with the integrated universal remote
control.
Online Edition for Part no. 01 40 2 900 867 - 03 12 490
Interior equipment
A list of compatible hand-held transmitters is
available on the Internet: www.homelink.com
HomeLink is a registered trademark of Johnson
Controls, Inc.
Control functions on the interior mirror
▷ LED, arrow 1.
▷ Buttons, arrow 2.
▷ Hand-held remote, arrow 3, is needed for
programming.
Programming
General
1. Switch on ignition.
2. Initial operation:
Hold down the right and left button on the
interior mirror at the same time for 20 sec‐
onds, until the LED on the interior mirror
flashes. All programming of the buttons on
the interior mirror is deleted.
3. Keep hand-held transmitter for the system
to be operated approximately at a distance
of to 30 cm, 2 to 12 in1 to cm away from the
buttons on the interior mirror. The gap re‐
quired depends on the hand-held transmit‐
ter.
4. Hold down the button of the desired func‐
tion on the hand-held transmitted and the
buttons to be programmed on the interior
Controls
125