Indicator Lamp - BMW X3 xDrive20i 2013 Owner's Handbook Manual

Controls
During the interruption, press the rocker switch.
With the system switched on, the driven speed
is maintained and saved as the desired speed.
It is displayed in the speedometer and briefly in
the instrument cluster, displays in the speed‐
ometer, see page 108.
When maintaining or saving the cruise control,
the Dynamic Stability Control DSC will be
switched on if required.
Changing/maintaining speed
By pressing the rocker switch without interrup‐
tion, the current driven speed can also be main‐
tained and saved.
Adapting the desired speed
Adapt the desired speed to the traffic con‐
ditions and always be prepared to apply brakes,
as otherwise there is a danger that accidents
might occur.◀
Press the rocker switch repeatedly upwards or
downwards until the desired speed is set.
With the system active, the speed that is then
shown is set and will be achieved on a clear road.
108
Driving comfort
Online Edition for Part no. 01 40 2 900 867 - 03 12 490
▷ Each time the rocker switch is pressed
lightly towards the resistance point, the de‐
sired speed is increased or decreased by
approximately 1 km/h, 1 mph.
▷ Each time the rocker switch is pressed be‐
yond the resistance point, the desired speed
is increased or decreased to the next multi‐
ple of 10 km/h on the speedometer display.
▷ Pressing the rocker switch until the resist‐
ance point is reached and holding acceler‐
ates or slows down the vehicle without
pressing the accelerator. The speed is main‐
tained after letting go of the rocker switch.
Pressing beyond the resistance point re‐
sults in greater vehicle acceleration.
Calling up the desired speed
Press the button.
The saved speed is regained and maintained.
Displays in the instrument cluster

Indicator lamp

Depending on the equipment the indi‐
cator light in the instrument cluster
shows whether the system is switched
on.
Desired speed
▷ Marker illuminates green: the
system is active.
▷ Marker illuminates orange:
the system is interrupted.
▷ Marker does not illuminate:
the system is inactive.
Brief status display
Selected desired speed.