Chapter 4 Connection
4.1
Ethernet Port
Connect a Ethernet port of the switch to the computer by RJ45 cable as the following
figure shows.
Figure 4-1
4.2
SFP+ Port
Connect an SFP/SFP+ transceiver or an SFP+ cable to the SFP+ port. Make sure the
SFP+ module minimum bend radius is met when using the SFP+ cable.
The SFP+ ports support 10G connection by default. If you are using a gigabit SFP
module, please configure the speed of the corresponding SPF+ port as 1000M.
Figure 4-2
4.3
Verify Installation
After completing the installation, please verify the following items:
There are 5 to 10cm of clearance around the sides of the device for ventilation and the
■
air flow is adequate.
The voltage of the power supply meets the requirement of the input voltage of the
■
device.
JetStream 12-Port 10GBase-T Smart Switch with 4 10G SFP+ Slots
Connecting the RJ45 Port
RJ45 Port
Inserting the SFP+ Module
RJ45 Cable
SFP+ Port
SFP+ Transceiver
Connection
15