Care And Cleaning - Electrolux EBSL7 User Manual

18 www.electrolux.com
2. Set the heating function.
3.
Press
display shows Duration .
4. Set the time.
5.
Press
display shows SET + GO .
6. Press OK to confirm.
To start SET + GO function, press any
sensor field (except for
ing function starts.
When the heating function ends, an
acoustic signal sounds.
• When the heating function operates,
the Function Lock function is on.
The automatic switch-off works
with all functions, except Light ,
Duration , End Time and Core
Temperature Sensor.
10.6 Cooling fan
When the appliance operates, the cooling
fan activates automatically to keep the

11. CARE AND CLEANING

WARNING!
Refer to the Safety chapters.
Notes on cleaning:
• Clean the front of the appliance with a
soft cloth with warm water and a clean-
ing agent.
• To clean metal surfaces, use a usual
cleaning agent.
• Clean the oven interior after each use.
Then you can remove dirt more easily
and it does not burn on.
• Clean all oven accessories after each
use and let them dry.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a dish-
washer. It can cause a damage to the
nonstick coating.
again and again until the
again and again until the
). The set heat-
Oven temperature
30 °C - 115 °C
120 °C - 195 °C
200 °C - 230 °C
• You can activate and deactivate the
SET + GO function in the Basic Set-
tings menu.
10.5 Automatic switch-off
For safety reasons the appliance deacti-
vates after some time:
• If a heating function operates.
• If you do not change the oven tempera-
ture.
Switch-off time
12.5 h
8.5 h
5.5 h
surfaces of the appliance cool. If you de-
activate the appliance, the cooling fan can
continue to operate until the appliance
cools down.
11.1 Steam Cleaning
1. Remove the worst of the dirt manual-
ly.
2. Put 250 ml of water with 3 table-
spoons of vinegar directly into the
steam generator.
3. Activate the Steam Cleaning function
in the main menu. The display shows
the duration of the function.
4. An acoustic signal sounds when the
programme is completed. Press a
button to deactivate the signal.
5. Wipe out the appliance with a soft
cloth. Remove the remaining water
from the steam generator.
6. Keep the appliance door open for ap-
proximately 1 hour. Wait until the ap-
pliance is dry.