Panasonic TH-55LFV70U Operating Instructions Manual page 39

Adjusting POSITION
H-position Adjust the horizontal position.
H-Size Adjust the horizontal size.
Clock
(With PC input signal and when "RGB " is selected for "Component switching")
Phase
Eliminate the flickering and distortion.
Dot Clock
(With PC input signal and when "RGB " is selected for "Component switching")
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, adjust so
that any such noise is minimized.
Over Scan Turn image over scan On/Off.
Configurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (HDMI, DisplayPort, DVI-D IN 1, DVI-D IN 2, DIGITAL LINK, COMPONENT
VIDEO, VIDEO)
On
Notes:
• "Off" is effective during only "16:9" aspect mode.
• When "Off" is set, "H-Size" and "V-Size" cannot be adjusted.
1:1 Pixel
Adjusts the display size when 1125i or 1125p signal is input.
Mode
Notes:
• "On" is effective during only "16:9" aspect mode.
• Select On when you would like to replay 1920 × 1080 input signal.
• Applicable input signal:
1125 (1080) / 50i · 60i · 24PsF · 24p · 25p · 30p · 50p · 60p
• Select Off when flickering is shown around the image.
• H-Size and V-Size cannot be adjusted when On is selected.
Off
Notes:
• Depending on the input signal, the adjustable range for screen position differs.
If positions other than the adjustable range are selected, the position does not change.
Helpful Hint: ( / DEFAULT )
While the POSITION display is active, if either the DEFAULT button on the remote control is pressed at any time or the ENTER
button is pressed during "DEFAULT", then all adjustment values (except "Clock Phase" and "Dot Clock") are returned to the factory
settings.
V-position Adjust the vertical position.
V-Size
Off
On
Adjust the vertical size.
39