Adjusting Position - Panasonic TH-55LFV70U Operating Instructions Manual

Adjusting POSITION

1
Press to display the Position menu.
2
Select to adjust each item.
3
Press to exit from adjust mode.
Note:
• If a "Cue" or "Rew" signal from a VCR or DVD player is received, the picture position will shift up or down. This
picture position movement cannot be controlled by the Position function.
Auto Setup H-position/V-position, H-Size/V-Size, Dot Clock and Clock Phase are automatically adjusted.
When "Multi-screen setting" is "ON", this does not operate.
This setting only operates when a PC signal is input, and the aspect is "16:9".
Using Remote Control
Notes:
• Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright
image with borders and other objects are clearly shown, and then try auto setup again.
• Depending on the signal, out of alignment may occur after Auto Setup. Carry out fine tuning for the
position/size as required.
• If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,
1280×768@60Hz and 1366×768@60Hz), pre-selecting the individual signal in "XGA Mode" (see page
43) may results in correct Auto Setup.
• Auto Setup does not work well when a signal such as additional information is superimposed out of
valid image period or intervals between synchronizing and image signals are short.
• If Auto Setup cannot adjust correctly, select "Default" once and press ENTER then adjust Position
manually.
• If the picture goes off screen in the horizontal direction as a result of performing Auto Setup, perform
Dot Clock adjustment.
38
Press to select the menu to adjust.
Press to adjust the menu.
Note:
• Unadjustable items are grayed out. Adjustable
items differ depending on the input signal and the
display mode.
When
executed.
When Auto Setup does not work, "Invalid" is displayed.
on the remote control is pressed, "Auto Setup" will be
Position
Default Default
Auto setup
H-position 0
H-size 0
V-position 0
V-size 0
1:1 pixel mode Off