Pairing the projector
You can pair the projector with a Bluetooth device by doing the following:
1.
Turn on the Bluetooth device and set it in the paring mode.
2.
Set the projector in the Bluetooth mode and pair it with the Bluetooth
device.
System update
Ensure that the projector is connected to the Internet. Then you can go to the
Settings page of the projector to start System update. Follow the screen
instructions to complete the update.
Attention: During the system update, ensure that the projector is sufficiently
charged to prevent update interruption and system damage.
Resetting the projector
Ensure that the ac power adapter is disconnected from the projector. Then you
can reset the projector by doing the following:
1.
Insert a needle or a straightened paper clip into the reset hole to press
and hold the reset button for 5 seconds. Then release the button.
2.
The Power button LED flashes for 3 times. Then the resetting process is
completed.
Charging the projector
10
Need help?
Do you have a question about the ThinkPad Stack and is the answer not in the manual?