Working with electric power tools
Illustration
Adapt the adapter to the connection diameter of the
electric tool using a knife if necessary.
Connect the adapter to the handle of the suction
hose and connect it to the electric tool connection.
Connect the mains plug of the electric power tool to
the vacuum cleaner.
Illustration
Switch the vacuum cleaner to Position II and start
working.
Note: As soon as the electric tool is switched on, the
suction turbine starts with a 0.5 second delay. If the
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up
the remaining dirt in the suction hose.
Blower function
Cleaning hard-to-reach areas or, where vacuuming is
not possible, like leaves from a gravel bed.
Illustration
Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
Turn off the appliance.
Illustration
Hook the floor nozzle into the parking position.
Finish operation
Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
Remove the appliance head.
Empty dry dirt over the container.
Use the drain screw to empty liquids.
Tilt the container forward for easier emptying.
Storing the appliance
Illustration
Stow away the power cable and accessory at the
machine. Store the appliance in a dry room.
Care and maintenance
Clean the appliance and accessory parts made of
plastic with a commercial plastic cleaner.
If required, rinse the container and accessories
with water properly and dry them before reuse.
Illustration
Only clean the cartridge filter under running water;
do not wipe or brush. Let it dry completely prior to
installation.
Troubleshooting
Decreasing suction power
If the suction power of the appliance deteriorates please
check the following:
Accessories, suction hose or suction tubes are
clogged, please remove the obstruction using a
stick.
Illustration
Filter bag is full, install new filter bag.
Illustration
Cartridge filter is dirty, knock off dirt from cartridge
filter and clean under running water if necessary
and let dry well before reuse.
Replace damaged cartridge filter.
Technical specifications
Mains voltage
Frequency
Output P
nom
Max. connection output of appli-
ance socket
Mains fuse (slow-blow)
Container capacity
Water intake with handle
Water intake with floor nozzle
Power cord
Weight (without accessories)
Sound pressure level
(EN 60704-2-1)
Subject to technical modifications!
Customer Service
Australia
KÄRCHER Pty. Ltd.
40 Koornang Road,
Scoresby, Victoria 3179
1800 675 714 (Free Call)
www.karcher.com.au
New Zealand
Karcher Ltd.
66 Allens Road,
East Tamaki, Aukland
(09) 274-4603
www.karcher.co.nz
9
220 - 240
V
1~50-60
Hz
1000
W
1300
W
10
A
17
l
10
l
8
l
H 05VV-F3G1,5
6,0
kg
75
dB(A)