Lights And Visibility - Seat Arona Owner's Manual

Lock the driver's door with the key and hold
–
the key in the <zitat>lock</zitat> position un-
til all the windows are closed
Programming convenience opening in the
Easy Connect*
Select: button > function button SET-
–

TINGS > Opening and closing > Con-
trols for electric windows
choose between all the windows ( All ), on-
ly the driver's ( Driver ) or none ( Deacti-
).
vated
WARNING
Never close the windows without due care
●
or proper control. There is a risk of suffering
injury.
For safety reasons, you should only use the
●
remote control open and close functions with-
in about 2 metres of the vehicle. To avoid in-
juries, always keep an eye on the windows
when pressing the button to close them. The
windows stop moving as soon as the button
is released.
One-touch opening and closing*
One-touch opening and closing means you
do not have to hold down the button.
›››
Buttons Fig. 145 , ,
1 2 3
two positions for opening windows and two

Lights and visibility

for closing them. This makes it easier to open
and close windows to the desired position.
One-touch closing
Pull up the window button briefly up to the
–
second position. The window closes fully.
One-touch opening
to
Push down the window button briefly up to
–
the second position. The window opens
fully.
Resetting one-touch opening and closing
The automatic open and close function will
–
not work if the battery has been temporari-
ly disconnected. The function can be re-
stored as follows:
Close the window as far as it will go by lift-
–
ing and holding the electric window switch.
Release the switch and then lift it again for
–
1 second. This will re-enable the automatic
function.
If you push (or pull) a button to the first
stage, the window will open (or close) until
you release the button. If you push or lift the
button briefly to the second stage, the win-
dow will open (one-touch opening) or close
(one-touch closing) automatically. If you op-
erate the button while the window is opening
and have
4
or closing, it stops at this position.
Lights and visibility
Lights
Control lamps
 It lights up
›››
page 145.
Rear fog light switched on

It lights up
Left or right turn signal.
The control lamp flashes twice as fast when a turn signal
is faulty.

It lights up
›››
Main beam on or flasher on page 145.
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
WARNING
›››
Observe the safety warnings
symbols on page 122.
in Warning
143